Description

The ER2 microwave sensor detects human body motion to control any of Skydance’s range of RF receiver / controllers.  Motion can be detected through plastic, glass and thin non-metal materials using the HF 10.525GHz system.  Detection range is up to 20m and can be adjusted from 100% to 10%, hold time is also adjustable from 10sec to 30min.

Upon human detection the ER2 can be set to activate the lights to a predefined Lux level whilst compensating for the surrounding ambient light. Lux levels can be set to: 50, 100, 150, 200, 250, 300 or 400lux.

RF Control

• Pairing the receiver is simply performed by: A short press of the match key on the receiver / controller.  Followed by an immediate press of the match key on the sensor.  The LED indicator on the controller will fast flash a few times, indicating the match is successful.

FEATURES:

• Active microwave motion detectors with HF system 10.525GHz, motion can be detected through plastic, glass and thin non-metal materials
• Built-in motion sensor and daylight sensor
• Powered by 9~24VDC, output RF 2.4G signal
• Matched with RF LED controller or RF dimmable LED driver use
• Detection area, time delay and daylight threshold can be set via knob potentiometer
• Wide detection area, range up to 20m in diameter
• Supports mounting height up to 15m
• 1 sensor can be paired to an infinite number of receivers

FUNCTIONS

This sensor is a motion RF switch, which turns on the light upon detection of motion, and turns off after a pre-selected hold time when there is no movement.

DETECTION PATTERN